Clog911 Services

    Sump Pumps & Grinders — Built to Last

    We install and service NexGen pumps — stainless steel construction, PSC motor technology, and real-world testing to over 4 million cycles. Battery backup, submersible, and sewage/effluent models for residential and commercial applications.

    Problem / solution

    Stop replacing cheap pumps every few years

    Most sump pumps sold at big-box stores use high-RPM motors with plastic housings and float switches that fail after a few seasons. You replace them, they fail again, and eventually one fails during a storm when you need it most.

    NexGen pumps solve this with PSC motor technology running at 1,700 RPM instead of 3,450 RPM — cutting wear on bearings, shafts, and seals dramatically. Stainless steel construction, enclosed switch systems that never contact water, and real-world testing to over 4 million cycles mean these pumps are built to outlast everything else on the market.

    Clog911 is proud to install and service the full NexGen pump line — submersible sump pumps, stainless steel models, sewage/effluent pumps, and 24-volt battery backup systems for residential and commercial applications.

    What we install & service

    Applications

    • Residential basement sump pump installations and replacements
    • Battery backup sump pump systems for storm and power outage protection
    • Sewage ejector and effluent pump installations
    • Commercial grinder pump systems
    • Sump pump pit and discharge line repairs
    • Grinder pump replacements and service

    NexGen pump lineup

    Pumps engineered to outperform and outlast

    Every NexGen pump comes completely assembled, tested, and put through multiple running cycles before shipment. We match the right model to your application.

    Model 3300

    Submersible Sump Pump — 1/3 HP

    The NexGen 3300 is a quiet, dependable submersible sump pump built for residential basements. With over 40 GPM flow and a motor rated for over 1 million cycles, it handles everyday water removal without the noise or burnout problems of cheaper pumps.

    • Over 40 GPM (gallons per minute) flow rate
    • Oil-filled shaded pole motor for quiet, reliable performance
    • Rated to cycle over 1 million times
    • Side intake passes 1/4" solids — stays clog-free
    • High capacity: 180 cycles per hour
    • Enclosed water level control isolated from water contact
    • 1, 3, and 5 year warranties available

    Model 6600

    Stainless Steel Sump Pump — 0.6 HP

    The NexGen 6600 is a groundbreaking 0.6 HP stainless steel sump pump that uses PSC motor technology — the most energy-efficient, low-amperage motor on the market. Running at 1,700 RPM instead of the industry-standard 3,450 RPM means bearings, shafts, and seals last dramatically longer. Tested to over 4 million cycles.

    • 0.6 HP PSC (Permanent Split Capacitor) motor technology
    • 300 Series stainless steel construction
    • Real-world tested to over 4 million cycles
    • Low amperage, low RPM (1,700 RPM) — bearings, shaft, and seals last longer
    • No floats to hang up or catch debris
    • Diverter flange eliminates cavitation — no need to drill holes
    • Automatic reset overload protector prevents motor burnout
    • 1, 3, and 5 year warranties available

    Model 6700

    Stainless Steel Sewage / Effluent Pump — 0.6 HP

    The NexGen 6700 handles sewage and effluent applications with the same PSC motor technology and stainless steel build as the 6600. The 2" discharge handles waste that standard sump pumps cannot, making it ideal for basement bathrooms, ejector pits, and commercial grinder applications.

    • 0.6 HP PSC motor technology with 2" discharge
    • 300 Series stainless steel construction
    • Real-world tested to over 4 million cycles
    • Low amperage, low RPM (1,700 RPM) for extended component life
    • Enclosed water level control — no floats to hang up
    • Corrosion inhibitors protect switch and electrical connections
    • Automatic reset overload protector
    • 1, 3, and 5 year warranties available

    Model 2400

    24-Volt DC Battery Backup Pump — 24V DC

    The NexGen 2400 is the battery backup solution for when the power goes out or the primary pump fails. Running on 24 volts DC (two 12V marine batteries), it delivers twice the power of most competitors with approximately 50 hours of cycle time. System includes pump, 24V charger, battery cases, and jumper cable.

    • 24-volt power — twice the power of most competitors
    • 15.5 feet total head — adequate for average residential basements
    • 50 GPM at 5 ft. head
    • Approximately 50 hours cycle time on fully charged batteries
    • Pressure-activated diaphragm switch for precise water level detection
    • Independent power source keeps system always ready
    • Totally submersible with 9.5 ft. power cable
    • 3 year warranty included

    Your local advantage

    Why Clog911 for sump pumps

    We do not just drop a pump in a hole. We assess the pit size, discharge routing, check valve condition, and electrical setup to make sure the installation is done right the first time.

    We chose NexGen because their pumps are built the way pumps should be built — stainless steel, low-RPM motors, enclosed switches, and warranties that back real performance. When we install one, we know it is going to last.

    Fast response when pumps fail

    A failed sump pump during a storm means water damage in hours. We prioritize pump failures and get your system back online fast.

    Wausau local, not a call center

    We know Central Wisconsin basements, water tables, soil conditions, and the pump configurations that work best in this area.

    One clear next step

    Whether you need a new installation, a replacement, or a repair, call (715) 301-9909 for a free estimate. We will recommend the right NexGen pump for your situation.

    FAQ

    Straight answers about sump pumps and grinders

    Clear information to help you choose the right pump for your home or building.

    Need help now?

    Get the right pump installed before the next storm hits.

    Call (715) 301-9909 or request a free estimate. We will assess your situation, recommend the right NexGen pump, and get it installed properly.

    Serving from 524 Park Ave, Wausau, WI 54403 | Same-day service available when scheduling allows

    (715) 301-9909Get Estimate